IMPORTANT: The batteries are permanently sealed in the product and cannot be removed or replaced.
Attempting to remove and/or replace the batteries will void the warranty. The battery in the remote
control is replaceable.
NOTE
• Do not mix old and new batteries.
• Do not dispose batteries into fire.
Batteries may explode or leak.
• Do not mix alkaline standard
(carbon-zinc), or rechargeable
(nickel-cadium) batteries.
• Replace batteries ensuring the correct
battery type, and as a simultaneous
act.
• Remove batteries if product is to be
left unused for a long time.
• Clean the battery contacts and also
those of the devices prior
to battery installation.
• The supply terminal is not to be short
circuited (+) (-).
• Non-rechargeable batteries are not to
be recharged.
• Batteries are to be inserted with the
correct polarity.
• Remove exhausted batteries promptly
and dispose of properly.
Check your local regulations for proper disposal instructions of batteries.
CAUTION:
Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna • Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interfer-
ence, and (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT.
This Class B digital apparatus complies with Canadian ICES-003.
