EN-10
CoNtrol uNit
The exterior of the Control Unit and the visible interior surfaces of the reservoir can be
cleaned with a soft cloth and one of the following cleaning agents:
•
Mild detergent
•
70% Isopropyl alcohol
•
100% Simple Green
®
•
Quaternary ammonium (such as Virex
®
– typically only found in a clinical use setting)
•
Cavicide
®
Procedure
:
•
Follow the manufacturer’s instructions and precautions for the cleaning agent you select.
•
Apply the selected cleaner to a soft cloth and wipe down all surfaces of the Control Unit.
•
Allow the Control Unit to dry thoroughly before storing it in the bag.
•
The Control Unit should be cleaned as needed.
do Not use:
•
Phenolic-based disinfectants (such as Amphyl
®
– typically only found in a clinical use
setting).
•
Any solvent-based cleaners on the Control Unit. Doing so will damage the plastics and
will void your warranty.
•
Abrasive materials to clean the Control Unit. Doing so will damage the plastics and will
void your warranty.
Caution
: The Control Unit is not a waterproof device. Do not apply a direct stream of any
liquid onto the Control Unit, submerge the Control Unit, or allow any liquid to pool on the
surface of the front panel of the Control Unit.
s t o r A G e
C l e A N i N G
When you are done using the System for the day:
•
Unplug the AC Adapter and the Connector Hose from the Control Unit.
•
Push the door release button to open the door.
•
Carefully pour out the ice and water.
•
Wipe off any excess water.
•
Store the Control Unit with the lid fully open to allow the interior to dry and preserve
the reservoir seal. Store the Control Unit in the Carry Bag or in another safe location.
Remember that your GRPro 2.1 Control Unit is a valuable piece of equipment and should
be treated with great care, like a laptop computer.
Storage Temperature Conditions: 33° - 120°F (1° - 50°C)
Relative Humidity: 10% - 95% non-condensing
Caution
: Do not keep in extreme cold or hot temperatures (below 33°F or above 120°F or
below 1°C or above 50°C). Do not leave in a hot or freezing car. Do not leave the Control
Unit in direct sunlight. The UV light may damage or discolor the Control Unit.
