Gamatronic Electronic Industries Ltd.
POWER+
SA
User Guide, Release 1.6
43
Installation and Start-Up Sequence
To start the UPS:
1.
Attach the load device, if desired, but do not turn it on until you have set
the UPS output voltage, as described below.
2.
Turn on the circuit breakers for the
AC input
, the
Bypass input
, and the
Battery
. The UPS performs a self test; this takes about a minute.
Afterwards, you should see the following screen.
Verify proper number of input and output phases
Before turning the UPS on for the first time, verify that the UPS’s setting for number
of input and output phases is correct for your requirements. The phase setting can
be seen on the second page of the Profile screen, shown here with the phase
setting highlighted.
See “UPS Profile screens” beginning on page 19 for instructions on how to display
the Profile screen.
Set the output voltage
Before turning the UPS on, you must set the UPS nominal output voltage, if needed.
See “Changing the nominal output voltage” on page 47.
