11
Copyright © GamaBit Ltd. 2017 - 2020. All right reserved.
2.
Email Configuration dialogue - Enter the email where you would like to receive
information from your controller. If you do not want to receive emails, leave the
email box blank and select "Do not ask me again". You can skip this dialogue and
leave it for later. For advanced setup, select E-mail Settings from the Settings tab.
3.
Controller Input dialogue - If you are planning to connect to your home automation
system using a smartphone/tablet, enter a name and leave the Remote Access
checked. If you choose to skip this configuration, you can do it later from the
Remote Control option in the Settings tab.
3.3.1 Add Device
Please, review the device instructions for each separate device that you would like to add.
Different devices join in different ways - it could be by pressing and holding a button for
a while, repeatedly switching on and off the power, removing and putting the battery,
etc. Most often, when the device is new and has never been added to the Zigbee network,
it is simply enough just to switch it on.
Once you have carefully read the device instructions follow these steps:
1.
If the device is battery-operated, make sure the batteries are properly installed.
2.
If the device has been previously added to other Zigbee networks, you will need
to reset it. If there are no explicit instructions for reset in your device's manual,
follow the steps for leaving the network. This is usually enough to reset the device.
3.
Select Add Device in the Houseper or Houseper Mobile application from the
Settings tab - the controller will open your Zigbee network for new devices to join
in within the next 60 seconds.
4.
Follow the Join Network instructions of your device.
5.
After the device is successfully added to the controller a "New device found!" notice
will appear on the Houseper application screen.
6.
Please, wait until the controller discovers the full functionality of the device.
Undiscovered devices remain at the top of the list in the Houseper apps section.
In the discovering process, you can track how the device name and information
changes depending on the information collected by the controller. You can also
monitor the appearance of more than one device when the physical appliance
contains more than one logical device.
7.
Once the device is fully discovered, it will appear in the Houseper mobile
application.
The device being successfully joined to the Zigbee network, you can now access its
detailed information, change its name, set a room, and test its features. You can find
additional information in the Devices section of the current User Guide.