3
NOTE
: The following steps are for reference only. Consult your local hardware store
for the best installation method for your surface.
Installation Instructions
1.
Place the assembled light fixture on top of your existing
3” post and
hand tighten the 3 provided screws to secure
the lamp.
Note:
Installing the light on or near a wall may limit the
functionality of the solar panel for sun exposure. Make sure
the lamp is mounted so direct sun exposure is available.
Operation Instructions
1.
Turn the external operation switch to the Low or High
position
(Fig. 3)
.
2.
according to your preferences:
a.
Low: For softer light and longer duration.
b.
High: For brighter light output.
2.
The solar lamp will automatically operate at dusk.
Replacing the Batteries
(After several years of use, the batteries may need replacing)
1.
Make sure the ON/OFF switch is in the “OFF”
position (0).
2.
Unscrew the four screws on the underside of
the lamp top to detach it from the lamp.
3.
Unscrew the battery compartment’s screws
located on the silver reflector and remove
the compartment doors.
4.
Unclip the battery connectors and remove
the old batteries. Make sure the new
batteries are high quality
–
2 Li-Ion Battery
packs (3.2 Volt / 1500 mAh) with matching
connector
(Fig. 4)
.
5.
Install the new batteries into the battery
compartment.
6.
Reassemble the unit by reversing the above procedure.
(Fig. 4)
(Fig. 3)
Replacement Solar LED Bulb and batteries are available at
or via our Toll free number: +1-800-835-4113
