6
Blades
nearer
to
the
reducer
screw off and remove
М5х20 bolts from the clamps (see:
Figure 10) from the upper section of the handlebar,
preventing the nuts from falling out.
3. Set the proper part of the cross-tube in the holes of the
clamps, and fasten it with the bolts removed earlier.
Figur
e 8
Note:
on the blades of the component,
embossed letters (L), (R) are found, meaning L- left-side
blade, R-right-side blade.
Warning
Figure
11
М8х100 bolts
1. Setting the blades on the reducer
Place the blade holders (assembled with blades) on the
reducer shaft (Figure 9, Item 3) from both sides, fit the
holes of the reducer shaft with holes of blade holders, and
fasten them with bolt pins and cotter pins (Figure 9, Item 1
and Item 2).
Note:
set the cutting edges of blades in the direction of
rotation.
3
1
2
Figure
9
4. Setting the handlebar
The handlebar consists of the following (see: Figure 10):
Right section of handlebar;
Left section of handlebar;
Cross-tube connecting the right and left side
When installing the handlebar, do not turn over or break the
control cable.
5. Adjusting the clutch cable tensioning
With the clutch lever being released (not pressed), pull the
pull starter handle several times. During this, the blades
should not turn over. If they still turn over, loosen the cable
tensioning by means of the regulating sleeve.
1. Loosen the fastening nut (see: Figure 12, Item 2) and
slightly screw the sleeve (Item 1) in the body (Item 3).
2. Strongly tighten the fastening nut to the body of the
regulating sleeve.
3. Check the clutch cable for tensioning.
Figure
12
Note:
In the following, in case of the drive-
belt’s wearing and
elongating the tension can be set by means of the sleeve
which is found in the clutch lever body (at the beginning, the
sleeve is fully screwed in).
For tightening the clutch cable, screw off the fastening nut
(See: Figure 13) and slightly screw off the cable sleeve.
Figure 10
1. Fit the fastening holes of the left side and right side of the
handlebar together with the holes found in the upper
section of the handlebar holder, then fasten them with
М8х100 bolts and nuts (see: Figure 11).
2. By means of a 4-mm key (not included in the scope of
supply),