Gama Garden GLM-40P Easy, Instruction Manual

Page: 17 / 21

Acquaer Ltd. www.gamagarden.eu
H-
4900, Fehérgyarmat, Szatmári utca 11.
17/21
b) Remove the spark plug and pour inside the spark plug hole about 3 cm of clean
engine oil. Close the hole with a cloth, then pull, slowly and carefully, the starting rope
so that, with a few engine revolutions, the oil will be distributed on the cylinder inner
walls. Reinstall the spark plug without connecting the cable cap.
IMPORTANT : Never get rid of used oil, fuel or other pollutants in unauthorised places.
IMPORTANT : If necessary, you can lift the front side of your lawnmower or you can tip it
on its left side only, making sure not to spill any fuel or oil.
Change of cutter blade (See A12)
Disconnect spark plug cap before proceeding
Use protective gloves when changing blades to avoid cutting yourself.
Blunt and damaged blades tear up the grass and make the lawn unsightly after
mowing. New well-sharpened blades cut off the grass. This gives a green and fresh
appearance after mowing.
Always check the blades after a collision. First disconnect the spark plug cable. If the
blade system has been damaged, defective parts should be replaced. Always use
genuine spare parts.
To replace the blade(5), slacken the screw(7). Fit the new blade so that the stamped
GAMA GARDEN GLM40-10012587 logo is turned up facing the blade holder (not
facing the grass). Reinstall as illustrated. Tighten the screw.
properly. Tighten torque 57 Nm (fig. A12)
When replacing the blade, the blade screw should also be replaced.
The guarantee does not cover damage to the blade, blade holder or engine caused
by running into obstacles.
When replacing the blade, the blade holder and the blade screw, always use
genuine spare parts.
Non-genuine spare parts can entail a risk of injury or damage, even if they fit the
machine.
SHARPENING OF THE BLADES
Sharpening of the blades must be done by wet method grinding, using a whetstone
or a grindstone.
For safety reasons, the blades should not be sharpened on an emery wheel. Too
high temperature
could cause the blade to become brittle.
Once the blade has been sharpened, it must then be balanced to avoid
vibration damage.