3.
Install the panel on the indoor unit
temporarily. Put the hook on the
hook which is on the indoor unit
opposite to the stepping motor on
the panel. (two hooks)
4.
Put other 2 hooks on the main hook
temporarily. (Do not tangle the wire
of the stepping motor into the sealed
material)
Connect to the corresponding terminals
while connecting the indoor unit with the
outdoor unit.
Panel installation
1.
Position the stepping motor on the
panel to the pipe end of the indoor
unit as shown in figure 4.
2.
panel installation
CAUTION!
5.
Fasten the four hexagonal screws
on the hook by 15mm. (Panel will
lift)
6.
Adjust the panel following the ar-
row as shown in figure 4, adjust
the panel to connect with the
ceiling.
7.
Tighten the screw until the sealing
material between the panel and the
indoor unit is reduced to 5~8mm.
