3.
Wiring of the decorating panel (Re-
fer to figure 7)
!
Connect the two terminals of the
wire of the stepping motor on the
panel.
Figure 7
If the lift level and drainage pipe of the indoor units
are not affected, you can adjust the height of the
indoor unit through the hole on the corner of the
panel.
No crack is permitted
Figure 6
Improper screw tightening will re-
sult in malfunctions as shown in fig-
ure 5.
After tightening screws, readjust
the height of the indoor unit, if there
is crack between the ceiling and
decorating panel.
CAUTION!
1.
2.
*After installing the panel, make sure
that there is no crack between the
unit and the panel.
