v
Version 1, 12
th
March 2020 Page
3
of
4
3. Secure Inlet Body and Mouthguard Outlet
Tighten the screws on the inlet body as shown.
Do not overtighten.
Secure the mouthguard outlet underneath with the
supplied cup washer and back nut.
4. Fit handle
Position and fit the handle and grub screw as shown.
Tighten firmly using the supplied hex key.
5. Fit Flexi-hose
Fit flexi-hose to mouthguard outlet and inlet body
as shown.
6. Testing
Once the drinking tap has been installed and tested for
leaks, the water height may be adjusted to suit the
available pressure.
To adjust water flow
1. Remove the blanking screw
.
2. Adjust the water height by turning the regulator screw
.
3. Once desired height has been achieved, replace
blanking screw.
Note: The full range from minimum flow to maximum flow is
only ¼ turn.
Water
Supply
