Galvani A2B, Owner'S Manual

Page: 31 / 48

31
Removing rear wheel
1. Ensure that the battery is disconnected.
2. Remove the cable retaining clips using
an appropriate allen key also located on
the underside of the left hand chain stay.
3. Disconnect the motor power and motor
controls connectors.
4. Using a 19 mm spanner, loosen and
remove the hub axle nuts.
5. Loosen and remove the torque arm
retention bolt from the left hand side
drop out.
6. Remove the torque arm from the A2B by
sliding it off the axle.
7. Remove the rear wheel by sliding it
out of the frame while disengaging the
chain from the freewheel.
Re-installing rear wheel
Reverse the removal instructions (7-1).
• Re-install the torque arm. Failure to do so
will result in damage to the frame.
• Ensure correct replacement of the chain
on the front and rear chain rings.
• Install the cable clips for the motor cable
to the frame.
Ensure that the rear wheel is properly
centred in the frame before securely
tightening the axle nuts to 60 Nm.
Ensure that the brake disc is correctly
inserted in the brake calliper, and the wheel
rotates freely without interference from the
brake shoes.
If you are unsure about this brake
set-up and adjustment procedure, please
take your A2B to your A2B dealer and
ask for assistance in adjusting the brakes.
Improperly adjusted brakes may cause
reduced braking performance, leading to an
accident that could result in serious or fatal
injury and/or property damage. DO NOT
ride your A2B if you are not confident that
the brakes are working properly.