ENG
27 / 36
26
CAUTION:
– If the dish is not fitted correctly on the propulsion unit, the safety switch will not allow to put the
motor in operation.
– When the blender is in the state of idle operation, e.g. the blade fails to touch the foods, unplug
the unit until the foods have been relaxed.
– Maximum time of operation is
60 sec
., then leave the appliance rest and cool down for approx.
3 min.
If you process big amounts of food, divide them in separate portions so that you keep )
recommended times of operation and rest of the propulsion unit.
Recommendation
– It is recommended to cut tough ingredients into small pieces. Do not process very hard
materials (e.g.
coffee beans, nutmeg and grains
etc
). The knife would be blunt soon.
– Hard ingredients (e.g.
legumes, soya beans, etc.) should be soaked in water before processing.
– The longer you process the food with the mixer, the smoother the result will be.
– In the case of liquids that create foam (e.g.
milk), never fill in the container
B
up to the gauge
mark „
MAX
“ to prevent overflowing.
– If you are not satisfied with the result, switch off the appliance, mix the ingredients with spatula,
take some part of the ingredients or add a little liquid.
PROCESSING GUIDE
food
Maximum amount Approximate time
[seconds]
Preparation
(cm)
Children‘s food, soups, sauces
100 – 400 ml
60
–
Shakes and cocktails
100 – 500 ml
50
–
Food and vegetables
100 – 300 g
30
2 x 2 x 2
CLEANING AND MAINTENANCE
(pic. 10)
Unplug the appliance from power supply by taking the plug of the power cord out of
a socket! Do not use rough and aggressive detergents!
Clean drive unit
A
with a soft and wet
cloth with a little detergent.
Make sure that water does not get inside the appliance!
Wash the accessories in hot water with a detergent right after use, rinse it in clean water and wipe
till dry (you can also wash the accessories in a dishwasher).
Be very careful when cleaning the
knife!
Make sure that the cutting edges of the accessories are not in contact with hard objects
that make them blunt and thus they reduce their effectiveness. If sealing
B1
or
C3
is worn out or
damaged, replace it with a new one (of a similar type).Some food can colour the accessories in
some way. But this does not affect the function of the appliance and it is not a reason for a claim.
This colouring usually disappears after some time. Never dry plastic moldings over a heat source
(e.g. heater, electric/gas stove). Take care that the binding surfaces and the sealing elements are
functional.
STORAGE
You may coil the supply cord
A3
into the space in the housing of the propulsion unit. Store
the appliance after cleaning at a dry, dustfree and safe place, out of reach of children and
incapacitated people.
