3Ennnn Gallagher T30 Reader Installation Note| DRAFT2 | July 2020
Copyright © Gallagher Group Limited
Page 9
5.
Connect the terminal tail extending from the facia assembly to the building cable.
An HBUS device connects to a Gallagher Controller 6000, Gallagher 4H/8H Module, a Gallagher HBUS
Door Module, or a Gallagher HBUS 8 Port Hub.
HBUS connections:
HBUS connections terminated:
To terminate an HBUS device, connect the
Orange
(HBUS Termination) wire to the
Green
(HBUS A)
wire.
PIV readers connect to the Gallagher Controller 6000 High Spec PIV (C305101) only.
6.
Fit the facia assembly into the bezel by clipping the small lip, into the top of the bezel and holding the
top, press the bottom of the facia assembly down into the bezel.
Note:
Ensure that there is no pressure upon the wire set as it exits the terminal. Ensure the wire set
does not exit the reader at a sharp angle, as this may compromise the integrity of the wire set's water
seal.
7.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) through the hole
at the bottom of the bezel to secure the facia assembly.
Note:
The Torx Post Security screw needs only to be lightly tightened.
8.
Removal of the facia assembly is a simple reversal of these steps.
9.
Configure the terminal in Command Centre. If the terminal is connected as an HBUS device, refer to
the topic
"Configuring an HBUS Terminal"
or the topic
"Configuring the PIV Card Reader"
in the
Command Centre Configuration Client Online Help. If the terminal is connected as a Cardax IV device,
refer to the topic
"Creating Readers"
in the Command Centre Configuration Client Online Help.
