Connecting via Line Input
If your amplification system has a dedicated subwoofer line output
then you should connect your 4070 via the Line Input on the rear panel
using a good quality phono lead. Note that if your amplification
system has a mono subwoofer line out then use the Left/Mono socket
on your 4070.
Connecting via High Level Connections
Do not compromise the performance of your system by using inferior
quality cables! Gale recommends that high quality cables of 16 gauge
or higher be used. Your professional dealer will give you good advice.
Observing polarity is of the utmost importance while connecting your
loudspeakers. Ensure that the red (+) terminals on your amplification
system are connected to the red (+) on the subwoofer, and black (-) on
your amplification system to black (-) on your subwoofer.
Important Note:
Always unplug all A.C. powered components
before making any loudspeaker or component connections. This will
avoid the risk of electric shock or damage to your equipment.
Running In
Your new unit will require a total of approximately 10 hours of normal
use to allow the components to settle into their working routine and
reach their optimum performance.
Getting Started
8
Attaching feet to your subwoofer
Your 4070 subwoofer comes with feet and spikes which should be
fitted as outlined below.
The spikes attach to the bottom of the feet (as shown below left).
There are eight pilot holes on the bottom of the speakers. The feet are
located and secured here with the wood screws supplied (below right).
Level as required.
fig. b
fig. a
Drawing Title
Drawing Title
Checked By
Checked By
Drawing No
AP18039/1.
Drawing No
AP18039/1.
Revisions & Date
Revisions & Date
Material
125gsm
Material
125gsm
Colour Definition
Colour Definition
Pantone BLACK 100%
Pantone BLACK 100%
1: 31/05/05
2:
3:
4:
5:
1: 31/05/05
2:
3:
4:
5:
Gale 4070 manual
Gale 4070 manual
Signed off
VBW
Signed off
VBW
VLB
VLB
Drawn
Drawn
Sheet
Sheet
NTS
NTS
Scale
Scale
(Orig Only)
(Orig Only)
x
2
