Questions?
www.galbreathproducts.com
1-800-285-0666
11
6. In addition to the front stops, container and hoist
should always have a rear container hold-down
device. Disengage PTO and relieve all pressure in
the system before driving away. Fully retract the
tail before departing for all extended tail models.
DUMPING PROCEDURE
Review the following guidelines to perform the
dumping operation. These items do not cover every
possible situation which may occur, but are intended
to promote proper operation when combined with safe
work habits and common sense.
1. Examine the dump site. The area should be level,
solid, and clear of obstacles. Check for overhead
clearances such as power lines.
2. With hoist and container in the down position, open
the tailgate and secure the door in the open position
using the chain provided on the container door.
Engage PTO and raise hoist until load slides out.
Before raising the hoist, check both sides and rear of
the hoist for personnel. Do not raise the hoist if anyone
is close enough to be hit should the hoist tip over. Also,
check for any personnel that may be heading into the
area during the dumping operation. Failure to follow
these procedures may result in severe injury or death.
WARNING
The container and hoist must be equipped with the
proper front stops and rear hold-downs. The container
specifications must match the hoist specifications.
(Example: roller size and location, proper style hook
up, spacing between long sills, etc.). The container and
hoist must be in good working order. Failure to comply
with these requirements could result in serious injury
to persons and/or damage to equipment, and is the
operator/owner’s responsibility.
In the event that all of the load is not discharged or it
becomes necessary to move the unit forward, lower the
hoist and container to the full down or travel position
prior to any forward movement of the truck. Always
keep the tires properly and evenly inflated.
NOTICE
WARNING