7
KETTLE MAINTENANCE - CLEANING
After each popping period, wipe the inside and outside of
the kettle while it is warm (not hot) with a clean cloth. This
is important to keep salt and seasoning from forming a
carbonized material which not only lowers popping efficiency
but can cause excessive smoking or damage the kettle.
Clean the inside and outside kettle shell including the covers
and all attached parts with warm water and mild soap or
detergent solution (see Figure 2).
CAUTION
DO NOT IMMERSE THE KETTLE IN WATER OR ALLOW WATER TO ENTER
THE KETTLE SHELL SINCE THIS WILL DAMAGE ELECTRICAL PARTS
INSIDE THE ASSEMBLY.
To remove the kettle:
Turn off all switches and allow the kettle to cool. Use heat insulating gloves to remove a hot kettle.
Disconnect the twist lock plug at the end of the kettle conduit from its receptacle. Turn the kettle
handle counterclockwise 90° to release its latch. Hold the handle in this position while tipping the
kettle and handle down and pushing up on the bottom of the kettle to remove it from the hooks (see
Figure ).
To replace heat lamp:
Turn off all switches and allow kettle to cool to touch.
Remove the () screw holding the lamp shield and pull down
on lamp shield to remove it from the top liner. Replace the
heat lamp with the same type and wattage lamp. Do not
install a lamp higher in wattage than indicated on the label
located near the lamp socket (see Figure 3).
MAINTENANCE AND REPAIRS
Contact the factory, a service representative, or a local service
company for service or required maintenance.
Summary of Contents for G8
Page 31: ......
