Page 5 Galaxy Floor Sanding Machines, Operator’s Manual
The Dust Bag
is a high quality dust collector. It has a special wear-reducing surface on its floor-facing
side. You can attach it to the output end of the dust pipe by using the bag’s attached drawstring. Check
to ensue the bag is securely attached and the drawstring is not loosely hanging. You attach the bag’s
inlet to the dust pipe, draw the string and tie it. You can also attach it with the supplied bag clamp. You
place the bag’s inlet over the dust pipe’s output end and attach the bag clamp.
HOW TO PREPARE THE MACHINE FOR OPERATION
Warning:
Always make sure the power switch is in the “OFF” position and the machine is unplugged
from the electrical source prior to doing any maintenance.
How To Install Sandpaper Discs
Always use the right sized sandpaper discs. This unit requires 7” diameter paper with a 7/8”center hole. To
replace the sandpaper disc follow these steps:
•
Take off the special wrench that is clamped to the back of the machine.
•
Put the machine upside down.
•
Use the special wrench and remove the center bolt and beveled washer of the sandpaper holder. (To
loosen turn it counterclockwise). Take off the used sandpaper disc and place a new one on the sanding
pad. Fasten it with the sandpaper holder.
The Dust Bag
Unscrewing the Center Bolt
Installing Sandpaper Disc
