Fig. 3
Microphone plug pin numbers viewed from rear of pin
receptacle.
Be sure that the housing and the knurled ring of Fig. 2 are pushed back
onto the microphone cable before starting to solder. If the washer is not
captive to the pin receptacle body, make sure that it is placed on the
threaded portion of the pin receptacle body before soldering.
If the microphone jack is used to hold the pin receptacle during the
soldering operation, best results are obtained when the connections to
pins 1 and 3 are made first and then the connections to pins 2 and 4.
Use a minimum amount of solder and be careful to prevent excessive
solder accumulation on pins, which could cause a short between the pin
and the microphone plug housing.
6. When all soldering connections to the pins of the microphone plug are
complete, push the knurled ring and the housing forward and screw the
housing onto the threaded portion of the pin receptacle body. Note the
location of the screw clearance hole in the plug housing with respect to
the threaded hole in the pin receptacle body. When the housing is
completely threaded into the pin receptacle body, a final fraction of a
turn either clockwise or counterclockwise may be required to align the
screw hole with the threaded hole in the pin receptacle body. When these
are aligned, the retaining screw is then screwed into the place to secure
the housing to the pin receptacle body.
7. The two cable clamp retainer screws should now be tightened to secure
the housing to the microphone cord. If the cutting directions have been
carefully followed, the cable clamp should secure to the insulating jacket
of the microphone cable.
8. Upon completion of the microphone plug wiring, connect and secure the
microphone plug in the transceiver.
MEMO
- 15 -
- 16 -
Summary of Contents for DX-66V
Page 10: ...MEMO MEMO 17 18...
