24
Filling Your Spa
We water test each spa at our factory and water residue may remain in the
pipework. You may notice a smell related to this and may also notice some
residue on or in the spa that has settled during production, testing or transport.
This is completely normal and therefore, it is important you wipe out and then
sanitise your spa prior to first use, following the steps below:
1.
+
Make sure the power to your spa pool is turned off.
+
Remove one of your filters and place your garden
hose into the filter basket (this will help to prevent
air locks in the plumbing).
2.
+
Fill the spa pool to the recommended fill line,
indicated by the sticker on the inside of the spa.
+
Remove the hose and place the filter back into the
filter basket.
3.
+
Once full, turn on the power to the spa pool.
+
A priming cycle will automatically run, clearing the
pipes and testing the components.
+
Set your spa time and filtration cycles, following the
touchpad guide on page 26.
4.
+
Add the recommended chemicals to the water using
the Galaxy Super Chlor Start Up Kit guide on page 33,
or the simplesilver guide on page 37.
5.
+
Set the spa pool to your desired temperature.
38°C
6.
+
Ensure your cover is down and tightly secured,
then allow the spa pool to heat (six+ hours).
