Mini Circular Saw
Owner’s Manual & Safety Instructions
a.Connect the small end of the
vacuum adapt
or (8)
to the
dust extraction port (5)
on the tool.
b.Connect the other end of the vacuum
adaptor
(8)
to the end of a vacuum hose.
OPERATION
WARNUNG: Observe correct main voltage! The voltage of the power source
must agree with the voltage specified on the nameplate of the machine.
Switch On/Off
Before engage the
ON/OFF switch (15)
, check that the saw blade is properly fitted
and run smoothly, the blade clamp bolt is well tightened.
To start the machine, press the
ON/OFF switch (15)
and keep it pressed.
To stop the machine, release the
ON/OFF switch (15)
or when it is locked
with the
lock-off button (14)
, briefly press the
ON/OFF switch (15)
and then
release it.
Laser Function
WARNING: Do not stare directly at the laser beam, do not deliberately aim the
beam at personnel and ensure that it is not directed towards the eye of a person for
longer than 0.25s.
When you make the line of the cut on the work piece, the laser can help you get
better alignment.
a.Make sure line of the cut on the work piece.
b.Adjust the angle of cut as required
c.Plug in the machine and start the motor
d.When the blade is at its maximum speed (approximately 2 seconds), place the saw
on the work-piece.
e.Switch on the laser from the laser aperture using the
laser switch (21)
.
f.Align the beam with the mark on the work-piece and slowly push the saw forward
using both hands, keeping the red light beam on the mark.
Switch off the laser beam when completed the cut.
Cutting Methods
Parallel Cut Adjustment
a.
Loosen the lock knob of
edge guide (12)
.
b.
Slide the
edge guide (7)
through the slots in the shoe to the desired width.
Abb.7
