
SERVICE INSTRUCTION
S
E
R
V
IC
E I
N
S
T
R
U
C
T
IO
N
17
Troubleshooting
Drum light does
not work (option)
Observe recommended loading volumes.
The sediment on humidity sensor.
Drying cycle ends
shortly after
programme starts.
"END" light
illuminated.
Drying cycle lasts an
unusually long time.
Select a different program the next time
you dry (see “Drying programs” section).
Clean lint filter.
Wrong programme selected.
Filter clogged.
Incorrect volume of laundry.
Drying results
unsatisfactory
Mains plug is not plugged in.
Loading door is open.
Have you pressed the button?
Plug in at main socket.
Close loading door.
Press the button again.
Dryer does
not work
Light bulb is defective.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Load volume is too big.
Reduce load volume.
Reduce light bulb.
Select higher drying level
(e. g. Heavy instead of Strong).
Malfunction
Troubleshooting
Solution
If you are unable to identify or solve the problem, contact our service centre.
Before you call, make a note of the model, serial number and purchase date of
your machine: the Service Centre will require this information.
Grounding Instruction
This appliance must be grounded. In case of failure or damage, grounding can provide
a minimum resistance to reduce the possibility of electric shock. The power cord has
grounding wire with device and power cord with plug. Plug must be inserted into a
properly installed and grounded socket(in accordance with all local rules and standards).
Water Discharge
It's not necessary to discharge the
condensed water to the tank, it can
be drained out directly. change
drainpipe. Pull out the water pipe by
means of the arrow
direction, Then install
the drainpipe. Such
as the pliers can be
used if it is difficult to
do.
Unpacking your dryer
Caution
!
Before using the machine, the
packaging foam must be removed
from the drum.
1.Open the loading door.
2.Pull off adhesive strips from inside
machine on top of drum.
3.Remove the two packaging foam
from the machine.
two packaging foam