Galanz GLFW22WEA5A, Instruction Manual

Page: 19 / 52

17
MAINTENANCE INSTRUCTIONS
M
A
IN
T
E
N
A
N
C
E
I
N
S
T
R
U
C
T
IO
N
Cleaning the drain pump filter
The filter should be cleaned every 2 months
or when there is fault that the “E03” is on
the screen.
1. Disconnect the machine
from the mains electricity
supply and open the lower
cover with a screwdriver. 2. Place a container
under the pump.
Unscrew and remove
the filter.
3. Clean the filter
carefully.
NOTE
1. Change the water inlet.
2. Check the connection and
ensure it is secure.
3. Change the water sensor.
1. The water inlet valve is
damaged.
2. The connection between
the water sensor and wire is
not secure.
3. The water sensor is
damaged.
Possible Cause
The machine
fills overtime.
There is
a Door
lock alarm.
1. Water tap is not open.
2. Drain hose is put down.
3. Water inlet valve is damaged. 1. Open the water tap.
2. Hook up the hose.
3. Change the water inlet valve.
“E01” is
on the
screen.
Problem Error Code
The machine
drains
overtime.
Water
overflows
the machine./
Water sensor
works
abnormal.
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system
and clean it.
1. The drain hose is squashed
or kinked .
2. The drain pump filter is block.
3. The drainage
system pipes
are blocked .
1. Lock the door well.
2. Put the garment into the
drum.
3. Change the door lock.
1. The door is not locked well.
2. Garments is caught between
the door and seal.
3. Door lock is damaged.
Solutions
“E02” is
on the
screen.
“E03” is
on the
screen.
“E04” is
on the
screen.
Important:
If the machine is exposed to temperatures below 0°C, certain precautions should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position the end of this hose and that
of the inlet hose in a bowl. Run the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure that the room temperature
is above 0°C.