MOTO GAR
Page 11
CHAPTER 4. MAINTENANCE OPERATIONS. RECOMMENDATIONS.
In order for the equipment to have a long life we must follow some essential rules for maintenance
and use. Abide by these recommendations.
CORRECT MAINTENANCE OF THE EQUIPMENT WILL AVOID A GREAT PERCENTAGE OF FAULTS.
4.1 MOTOR MAINTENANCE. GENERAL RECOMMENDATIONS.
Follow Honda manual instructions for:
- Oil change.
- Air filter.
- Spark plug change.
- Cleaning fuel sieve cup.
- Adjusting carburettor.
4.2 ALTERNATOR MAINTENANCE. GENERAL RECOMMENDATIONS.
)
BLOW THE INSIDE OF THE MACHINE WITH COMPRESSED AIR FROM TIME TO TIME.
)
PLACE THE EQUIPMENT SOMEWHERE WHERE CLEAN AIR IS RENEWED.
)
KEEP THE MACHINE PANELS CLOSED.
)
KEEP THE WELDING ACCESSORIES IN GOOD CONDITIONS FOR USE.
)
DO NOT EXCEED THE EQUIPMENT DUTY CYCLE.
ONCE THE WELDING OPERATION HAS FINISHED AVOID DIRECT CONTACT OF THE ELECTRODE-HOLDER
CLAMP WITH THE WELDING EARTH CLAMP AND THE OTHER PARTS CONNECTED TO IT.
4.3 RECOMMENDATIONS FOR REDUCING ELECTROMAGNETIC COMPATIBILITY (CEM) PROBLEMS.
The user is responsible for the installation and use of the welding material according to the instructions in
this manual and the following recommendations.
Before installing the welding material, the presence of the following in the surrounding area must be kept
in mind:
•
Wiring for power, control, signalling, and telephones.
•
Radio and television receivers and transmitters.
•
Computers and other control equipment.
•
Critical security equipment.
•
People with pace makers or hearing aids.
•
Measurement and calibration equipment.
In order to reduce EMC problems, keep in mind the time of day when welding or other activities will be
carried out. Move possible interference victims away from the welding installation.
ALWAYS CONNECT THE MACHINE TO POWER USING AN EFFICIENT EARTH TAP.
IF PROTECTIVE DEVICES OR SUPPLEMENTARY ELECTRICAL SYSTEM FILTERS ARE NEEDED, CONSULT OUR TECHNICAL
SERVICE.
PERFORM THE MAINTENANCE OPERATIONS DESCRIBED IN THIS MANUAL.
USE THE SHORTEST WELDING WIRES POSSIBLE AND KEEP THEM PLACED NEXT TO EACH OTHER NEAR THE FLOOR.
IF THE WELDING PIECE IS GROUNDED, KEEP IN MIND OPERATOR SAFETY AND NATIONAL REGULATIONS
.
