Serial to Wi-Fi Start Up Guide
P
RELIMINARY
P
AGE
5
OF
12
C
ONFIDENTIAL
2.
Connect the Serial Cable provided with the kit to either the 6-pin UART connector as shown be-
low or to the DB9 connector depending on the type of cable that is being used.
Black Wire
Indicates
Pin 1
Pin 1
Black Wire
Indicates
Pin 1
Pin 1
3.
Launch the Tera-Term Application. Select serial port connection, and select the serial port identi-
fied in step 2. Set the port settings as shown below.
4.
Install the batteries provided with the kit into the battery holder.
NOTE: Make sure the power switch (SW1) is in the OFF position. Make sure that the battery’s
positive (+) terminal aligns with the battery holder’s positive (+) terminal indicator before inser-
tion. Improper placement of the battery may damage the evaluation board.
SW1
On
Off
SW1
On
Off
5.
Power on the Evaluation board by switching the power switch SW1 to the “ON” position. Tera-
Term will display “Serial to WiFi App” for an internal PA board (GS1011MIP-EVB) or “Serial
to WiFi App-Ext. PA” for an external PA board (GS1011MEP-EVB or GS1011MEE-DB).
6.
By default the board will not have a network setup. To look at the network stat type “at+nstat=?
In the tera-term window. To look for available wireless networks and associate with one, below
are the steps
a.
To scan for available Wi-Fi access points, type “at+ws” on the Tera-Term screen