16
Titan, Commander, SMART
IMPORTANT:
Do not drill any extra holes as this will invalidate your warranty.
1. Remove rubber feet from the rear casing if fitted. Mark the wall with
hole centres based on the dimensions shown (145 x 270mm). If
necessary offer the rear casing up to the wall to check alignment.
Do not use the casing as a template for drilling..
2. Drill holes in the wall on the marked positions. Select appropriate
screws, wall plugs etc., for the type of wall, bearing in mind that the
weight of the complete phone is around 3.5kg.
3. Ensure the Rear Casing is securely attached to the vertical surface
using the four 7mm diameter screw holes provided. No sealing
washers are necessary.
IMPORTANT:
Do not use countersunk headed fixing screws. Only use
round head, socket cap head or pan head screws. Take care not to
over tighten the screws, doing so may damage the case and will
invalidate your warranty.
4. Continue the installation by making the appropriate connections
(section 7).
5. Reconnect the ringer. Secure the telephone Front Casing to the
Rear Casing.
6.3.2
Pole mounting
Kit No 100-02-0208-001
This accessory is for mounting GAI-Tronics telephones on to the side of
round poles of 100mm to 200mm diameter, or on to square or
rectangular section uprights of 100mm to 150mm across the mounting
surface. For flat mounting on surfaces greater than 150mm across use
the desk or wall mounted methods as appropriate.