10
Titan, Commander, SMART
5.4. Commander
1. All connections are on the circuit board housed in the front casing.
2. To prepare for installation, undo the three retaining screws shown to
remove the front casing from the rear. The screws are not captive in the
front casing; a 5mm Allen key is required.
3. Carefully remove the front casing from the rear, taking care not to pull
the wiring between the two sections or damage the connector.
4. Disconnect the ringer connector from the circuit board, noting the
position and orientation.
5. The Commander telephone can be installed vertically to a wall or pole,
or used horizontally on a desk. Select the required mounting method
(section 6) and mount the rear casing first where applicable.
6. Route the required cables through glands as appropriate, and make
connections following section 7. Ensure that both cable entries are
sealed with either a gland or a black blanking plug as described.
7. Reconnect the ringer. Re-secure the telephone Front Casing to the
Rear Casing with the three retaining screws, ensuring a weatherproof
seal.
8. Programming or parameter changes can be made remotely, using a
tone phone or TMA (see section 8)
9. Test the operation of the telephone (section 3). Installation is now
complete.
Ringer
Ringer connector
TB2 - Additional
hookswitch
(Optional)
CON1 - Main
Terminal block
HD14 - Aux. inputs
(optional)
HD3 - Aux. outputs
(optional)
Circuit board
(PCB)