Gaggia Babila, Service Manual, Page: 56 / 66

GAGGIA BABILA 07 DISASSEMBLY
7/11
7.11 Gearmotor
Loosen the screws as
shown and remove the
boiler pin
- (G) Drain multi-way valve.
Reconnect the gear (B), making sure that the arrow is
aligned with the opening that contains the pin (P).
When re-mounting the motor and the transmission shaft,
make sure the guides (L) are inserted in the correct
housing.
Grease the shaft thoroughly and evenly.
The following are located inside the compartment protected
by the casing:
- The electric motor (A) with gears (B) and (C)
for transmission and timing of the dispensing unit.
- The dreg drawer presence sensor (D).
- The dispensing unit presence microswitch (E).
- The microswitch (F) that detects the idle phase of the
dispensing unit as well as that of the dispensing process.
- Remove the gear (C) that engages with the motor
transmission shaft motor transmission.
- Remove the large gear (B).
- Remove the motor (A) complete with the transmission shaft.
Loosen the screws as shown and
remove the boiler pin
H
L
A
E
B
C
A
D
F
B
G
P