Gaggenau WT260165, User Manual And Installation Instructions, Page: 47 / 56

Troubleshooting
en
47
Fault Cause and troubleshooting
The drying time is too
long. Heat exchanger is soiled.
▶
Run the basic appliance care programme
→
Page 41 .
The crease-removal
function takes too
long. A low ambient temperature extends the duration of the
crease-removal function.
No action required.
Humming, whirring or
pumping noises. Not a fault. The compressor, compressor ventilation or
condensation pump is active.
No action required.
The laundry is too
damp. The selected programme is unsuitable for the type of
fabric.
▶
Set a time programme for subsequent drying.
→
Page 26
The load is too large.
▶
Observe the programme's maximum load capacity.
→
Page 25
After the end of the programme, warm laundry feels
damper than it actually is.
1.
Remove the laundry from the drum as soon as the
drying programme has finished.
2.
Spread the items of laundry for cooling.
The selected dryness level is unsuitable.
▶
Change the dryness level. → Page 33
The dryness level is not adjusted.
▶
Adjust the dryness level. → Page 33
The load is too small.
▶
Set a time programme for subsequent drying.
→
Page 26
The moisture sensor is dirty.
▶
Clean the moisture sensor. → Page 44
The appliance has interrupted the drying process due
to the condensation container being full.
▶
Empty the condensation container. → Page 32
Creasing. The selected programme is unsuitable for the type of
fabric.
▶
Set a suitable programme. → Page 25
The load is unsuitable.
▶
Observe the programme's maximum load capacity.
→
Page 25
▶
Prepare the laundry. → Page 29