9
Hole for control knobs
The built-in control console can be integrated into the
lower cabinet at drawer level. Panel thickness:
5
/
8
" - 1"
(16 - 26 mm)
1
If front panel thickness is greater than 1" (26 mm):
Mill out front panel on rear side to the point that
the thickness doesn't exceed 1" (26 mm). Adjust
the measurements of the milled-out section to fit
the holding plate.
For flush mounting:
2
According to the figure, create the drill holes Ø 1
3
/
8
" (35 mm) for fixing in place the control knobs
in the front side of the lower cabinet. A drilling
template is included for precise positioning of the
drill holes.
For flush mounting:
PLQ
PLQ
[
[
PLQ
PLQ
PLQ
PLQ
[
[
PLQ
PD[
PLQ
PD[
