25
12.
Adjusting the appliance in the niche
m
Caution!
Never use a power-driven screwdriver for setting
the height of the appliance.
Risk of damage to the appliance!
z
Adjust the appliance to the existing furniture.
Keep the straight edge on the door, above the
positioning supports.
The positioning supports are set out for the following
overall strengths of the furniture doors to be mounted.
–
19 mm
–
38 mm
Re-examine the actual thickness of the doors to be mounted
in order where necessary, to be able to compensate possible
digressions.
The height-adjustable feet on the front and rear can all
be adjusted from the front.
Front:with a fixed spanner SW 13 mm.
Rear: with a 8 mm socket spanner with flexible shaft.
There is a mark on the base of the appliance which serves
as a standard measurement for setting the height.
When setting the height, raise the mark to 32 mm above
the ground.
z
Screw the height-adjustable screws as far downwards
as possible until the marking on the base has reached
the given height (32 mm).
Note:
This dimension is very important for the subsequent
adjustment of the cabinet frontage.
z
Adjust the front of the appliance with the spirit level.
Note:
–
Do not tip the appliance in the niche! When screwing
down the height-adjustable feet, proceed step
by step. Lower by alternating left to right.
–
The rear feet can be set more easily if the appliance
is not loaded at the rear.
–
When using a wooden plank as an alternative anti-tilt
mechanism as in point 7. of these mounting
instructions, turn the appliance as far as it will
go against the wooden plank.
Do not bend against the wooden plank.
