Gaggenau EB 388 610, Use And Care Manual

Page: 22 / 24

22
Self-cleaning ended
The
Ò
symbol flashes after the pyrolysis cleaning
operation has ended. The timer switches off heating
automatically.
The flashing stops as soon as any button is pressed or
if the temperature selector is set to 0.
Note: When the press the
~
button, the suggested
value 2:00 h appears again. Press the
~
button again
to start the self-cleaning process again.
Once the cooking interior has cooled down, wipe the
remaining ash out of the interior with a moist cloth.
Troubleshooting
You can often easily eliminate problems that may
occur on your own. Before calling customer service,
take into account the following information.
9
WARNING
Risk of electric shock
Incorrect repairs are dangerous. Repairs may
only be carried out by one of our trained after-
sales engineers. If the appliance is faulty,
unplug the mains plug or switch off the fuse in
the fuse box. Contact the after-sales service.
--------
Disruption Possible cause Solution
Appliance not working, no display Plug not inserted Connect the appliance to the electricity
mains
Power failure Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box whether the fuse
for the appliance is in working order
Operating error Switch off the fuse for the appliance in
the fuse box and switch it on again after
about 10 seconds
Appliance cannot be started Appliance door is not quite closed Close appliance door
Display of current temperature shows
¬¬
.
¬
Continuous signal tone
Power supply was interrupted Move the temperature selector to the 0
position and adjust the oven again.
Appliance switches off on its own. Safety shut-off: the appliance has not
been operated for longer than 12 hours Switch off the appliance and set it again.
Oven lighting is on, the
F
symbol is lit
and the appliance is not heating.
Your appliance is in the demo mode
1.
Disconnect the appliance from the
mains for a few seconds (switch off
the fuse)
2.
Switch on the fuse again, keep the
@
key pressed and set the temperature
switch to any position (not light!).
No time display when the appliance is
switched off Your appliance is in the energy-saving
standby mode Changing the basic setting for the time
display: See section entitled "Basic set-
tings".