18
Operating the appliance
Switching off the appliance
Short time after the end of the programme:
1
Switch off ON/OFF switch
(
.
2
Turn off the tap (not applicable if Aqua-Stop
fitted).
3
Remove the utensils when they have cooled down.
Note
When the programme ends, leave the appliance
to cool down a while before opening it. This will
prevent steam from escaping and causing long-term
damage to your built-in furniture.
Interrupting the programme
1
Switch off ON/OFF switch
(
.
The LEDs go out. The programme is saved.
If the door was opened on an appliance which has
a warm water connection or is heated, first leave
the door ajar for several minutes and then close.
Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out
of the appliance.
2
To continue the programme, switch on the ON/
OFF switch
(
again.
Terminating the programme
Terminating the programme (Reset)
1
Press START button
P
for approx. 3 sec.
The numerical display
)"
indicates
‹
:
‹‚
.
2
The programme sequence lasts approx. 1 min.
On the digital display
)"
is indicated
‹
:
‹‹
.
3
Switch off ON/OFF switch
(
.
Changing the programme
When the START button
P
has been pressed, the
programme cannot be changed.
The only way a programme can be changed is by
Cancel programme (Reset).
Intensive drying
The final rinse uses a higher temperature which
improves the drying result. The running time may
increase slightly. (Caution if utensils are delicate!)
1
Close the door.
2
Switch on ON/OFF switch
(
.
3
Hold down programme button
#
and press
START button
P
until the digital display
)"
•
:
‹
... is indicated.
4
Release both buttons.
The LED for button
#
flashes and the digital
display
)"
displays the factory setting
•
:
‹…
.
5
Press programme button
#
until the factory set
value
š
:
‹‹
is indicated on the digital display
)"
.
To change the setting,
1
Press the button
3
to switch the Intensive
drying on
š
:
‹‚
or off
š
:
‹‹
.
2
Press START button
P
.
The set value is saved.
