Gaggenau DF480700F, User Manual

Page: 28 / 48

en-us
Basic Operation
28
14.5 Setting options
You can set options to complete the chosen cycle.
Note: The available options depend on which cycle is se-
lected.
▶
Press the button for the relevant option.
a
The option is set and the option button flashes.
14.6 Setting the electronic delay time
You can delay the start of the wash cycle by up to
24 hours.
1.
Press ⁠.
2.
Press or repeatedly until the display shows the
right time.
Depending on the setting of the time display, the end of
the program is shown on the display either with "Finish
in" (e.g. 3h 25min) or "Finish at" (e.g. 3:20pm). You can
change this setting in the Basic settings
→
Page 29 .
3.
To activate the electronic delay time, press ⁠.
Note: To deactivate the electronic delay time, press
for approx. 4 seconds.
14.7 Starting the wash cycle
▶
Press .
a
The wash cycle has ended when the display shows
"Finished!".
Notes
¡
If you want to add more dishware while the appliance is
running, do not use the collecting tray as a handle for
the upper rack. You might touch the partially dissolved
tablet.
¡
You can only change a cycle in progress if you can can-
cel it first.
→
"Terminating the wash cycle", Page 28
¡
To save energy, the appliance switches off automati-
cally 10 minutes after the end of the wash cycle. If you
open the appliance door immediately after the wash cy-
cle has ended, the appliance will switch off after 4 sec-
onds.
14.8 Interrupting the wash cycle
1.
Press On/Off.
The program is saved and the appliance switches off.
2.
Press On/Off.
3.
Press to resume the wash cycle.
14.9 Terminating the wash cycle
To end a cycle early or to switch from one that has already
started, you will need to cancel it first.
▶
Press for approx. 4 seconds.
a
All displays light up.
a
As soon as the displays are off, the display shows "Pro-
gramme was terminated." and then "Finished!".
a
The cycle is cancelled and ends after approx. 1 minute.
14.10 Displaying wash cycle information
You can show information about cycles and options on the
display.
1.
Press ⁠.
2.
Press the cycle button or an option.
14.11 Switching off the appliance
CAUTION
To avoid risk of injury, always use caution when opening
the door during or following a wash cycle as hot water or
steam may escape.
▶
Do not fully open the door until water noises have
stopped and steam has subsided.
1.
Please note the information on Preventing Material
Damage.
2.
Press On/Off.