14
Switching off the appliance
Short time after the end of the programme:
Open the door.
Switch off ON/OFF switch
1
.
Turn off the tap (not applicable if Aqua-Stop fitted).
Remove the utensils when they have cooled down.
Warning
At the end of the programme please open the door fully
and not partially when emptying the dishwasher. Any
escaping water vapour could damage sensitive
worktops.
Interrupting the programme
Open the door.
Switch off ON/OFF switch
1
.
The LEDs go out. The programme is saved.
If the door was opened on an appliance which has a
warm water connection or is heated, first leave the
door ajar for several minutes and then close.
Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out of
the appliance.
To continue the programme, switch on the ON/OFF
switch
1
again.
Close the door.
Terminating the programme (Reset)
Open the door.
Press START button
10
for approx 3 sec.
is
indicated on the digital display
3
.
Close the door.
The programme sequence lasts approx. 1 min.
is indicated on the digital display
3
(buzzer
sounds).
Open the door.
Switch off ON/OFF switch
1
.
Close the door.
Changing the programme
When the START button
10
has been pressed, the
programme cannot be changed.
The only way a programme can be changed is by
Cancel programme (reset).
Intensive drying
The final rinse uses a higher temperature which
improves the drying result. The running time may
increase slightly. (Caution if utensils are delicate!)
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button
A
and press START
button
10
until on the digital display
is
indicated.
Release both buttons.
The LED for button
A
flashes and the digital
display displays the factory setting
.
Press programme button
A
until the factory set
value
is indicated on the digital display
3
.
To change the setting,
Press the button
C
to switch intensive drying on
or off
.
Press START button
10
.
The set value is saved.
Close the door.
Interior light
*
20
The interior light comes on when the door is opened
irrespective of whether the ON/OFF switch
1
is
switched on or off. When the door is closed or ajar, the
light is off.
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button
A
and press START
button
10
until
is indicated on the digital
display.
Release both buttons.
The LED for button
A
flashes and the digital
display displays the factory setting
.
Press programme button
A
until the factory set
value
is indicated on the digital display
3
.
To change the setting,
Press the button
C
to switch the interior light off
or on
.
Press START button
10
.
The set value is saved.
Close the door.
* depending on model
