13
Switching on the appliance
Turn on the tap fully.
Open the door.
Switch on ON/OFF switch
1
.
The display of the last selected programme flashes.
This programme remains selected if no other
programme button
2
is pressed.
The expected programme duration flashes on the
digital display
3
.
Press the START button
10
.
Close the door.
The programme starts running.
Optical display while the programme
is running
*
* depending on model
While the programme is running, a light spot shines on
the floor under the appliance door. Do not open the
dishwasher door until the light point is no longer visible
on the floor.
If the appliance is installed at eye-level, with flush
furniture front, the light point is not visible.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button
A
and press START
button
10
until on the digital display
is
indicated.
Release both buttons.
The LED for button
A
flashes and the digital
display displays the factory setting
.
Press programme button
A
until the factory set
value
is indicated on the digital display
3
.
To change the setting:
By pressing the
C
button, you can switch the
function off
or on
.
Press START button
10
.
The set value is saved.
Close the door.
Remaining running time display
When the programme is selected, the remaining
running time of the programme is indicated on the
digital display
3
.
The running time is determined during the programme
by the water temperature, the number of utensils as
well as the degree of soiling and may vary (depending
on the selected programme).
Timer programming
You can delay the start of the programme in 1-hour
steps up to 24 hours.
Open the door.
Switch on ON/OFF switch
1
.
Press
8
+ button until the timer programming
display
7
jumps to
.
Press
8
+ or – button until the displayed time
corresponds with your requirements.
Press START button
10
, timer programming is
activated.
To delete timer programming, press the
8
+ or –
button until
is indicated on the digital display
7
.
You can change your programme selection at any
time until the programme starts.
Close the door.
End of programme
The programme has ended when the value
is
indicated on the numerical display
3
.
The end of the programme is also indicated by an
acoustic signal.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button
A
and press START
button
10
until on the digital display
is
indicated.
Release both buttons.
The LED for button
A
flashes and the digital
display displays the factory setting
.
Press programme button
A
until the factory set
value
is indicated on the digital display .
To change the setting,
press programme button
C
.
Each time the button is pressed, the set value
increases by one level; when the value of
has
been reached, the display jumps back to
(off).
Press START button
10
, the set value is saved.
Close the door.
