10
21"
(533mm)
14"
(355mm)
Figure 18
Hot Water Supply Line
and Electrical Supply
Cable Position in
Channels
Door Panel Installation
PLACING THE DISHWASHER
1
Straighten and position the hot water supply line and
the electrical supply cable as shown in
Figure 18
so that they will align with their channels under the
dishwasher base.
2
Position the dishwasher close enough to the
enclosure so that you can run the dishwasher drain
hose to the under sink drain connection. Make certain
that the hot water supply line and the electrical supply
cable are in their channels under the dishwasher
base, as shown in
Figure 17
.
3
Slide the dishwasher into the opening making sure
that the hot water supply line and the electrical supply
cable stay in their proper channels.
4
Make sure the dishwasher is level. Adjust the rear
leveler by turning the center screw at the front of the
dishwasher, as shown in
Figure 19a
. Turning the
screw clockwise raises the rear of the dishwasher.
Adjust the front levelers by turning them with a
screwdriver, as shown in
Figure 19b
. Turning the
levelers to the right raises the dishwasher. If additional
height is needed, shims may be added under the
leveler feet.
Figure 17
GLASS DOOR HEIGHT ADJUSTMENT
(model DI291730 only)
The door height on the Gaggenau model DI291730 can
be reduced by approximately 1/2“ in order to have the
dishwasher door bottom align with the cabinetry.
1
Remove the T15 screws on each side of the lower
door as shown in Figure 16 step 1.
2
Reduce the door height by turning the 5mm Allen
head screw at the door bottom as shown in Figure 16
step 2.
3
Secure the lower door with the T15 screws as shown
in Figure 16 step 3.
2
1
3
Figure 16
5 mm
Allen
Torx 15
max.
15
