Gaggenau DF264101, Information For Use

Page: 55 / 68

Troubleshooting
en
55
Fault Cause and troubleshooting
Detergent residue in
the appliance The lid of the detergent dispenser is blocked by the
tab and will not open.
▶
Position the tab in the detergent dispenser cross-
wise, not vertically.
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
▶
Select a more intensive Programme → Page 19 or
use Powder detergent → Page 30 .
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
▶
Change your detergent.
Water marks on
plastic parts. Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
▶
Select a more intensive programme.
→
"Programmes", Page 19
▶
Position tableware at an angle.
→
"Arrange tableware", Page 34
▶
Use rinse aid.
→
"Rinse aid", Page 29
▶
Set the water softening system higher.
→
"Setting the water softening system", Page 27
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door. Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent → Page 30 .
▶
Clean the appliance mechanically.
White coating is deposited in the appliance interior.
1.
Set the water softening system correctly.
→
"Setting the water softening system", Page 27
In most cases you will need to increase the setting.
2.
Change your detergent if required.
Special salt dispenser is not screwed tight.
▶
Screw the special salt dispenser tight.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door. Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent → Page 30 .
▶
Clean the appliance mechanically.
Hardness range is set incorrectly or the water hard-
ness is too high.
→
"Overview of water hardness settings", Page 27