16
Fault in water flow
To ensure an adequate water flow, the filter in the
AquaStop should be cleaned regularly.
1
Turn off the tap.
2
Unscrew the water inlet hose with the AquaStop
from the tap.
3
Clean the filter with a small brush.
Important:
Do not remove the filter under any
circumstances.
4
Screw the water inlet hose with the AquaStop to the
tap.
5
Slowly turn on the tap so it is fully open.
6
Check the connections and water inlet hose for
leaks.
If the appliance is cleaned and maintained regularly, this
will avoid faults.
Removing the appliance
1
Run emptying program. See instruction manual.
2
Turn off the tap.
3
Disconnect the mains plug.
4
Remove the water inlet and water outlet hoses.
5
Remove all screws. See installation.
6
Gently pull out appliance.
7
Pull the appliance out from the cabinet.
Summary of Contents for CM 470711
