9
Setting the cooktop
This section familiarises you with how to make
settings on your cooktop. The table contains cooking
methods and examples for the different heat settings.
Switching the cooktop on and off
The main switch is used to switch the cooktop on and
off.
To switch on: touch the
#
symbol. A signal sounds.
The lamp above the main switch and the
‹
displays
lights up. The cooktop is ready for use.
To switch off: touch the
#
symbol until the light above
the main switch goes out. All cooking zones are
switched off. The residual heat indicator remains on
until the cooking zones have cooled down sufficiently.
Notes
‒
The cooktop switches off automatically if all
cooking zones have been switched off for more
than 20 seconds.
‒
The settings remain stored for 5 seconds after the
cooktop has been switched off. If you switch it on
again during this time, the cooktop will operate
using the previously stored settings.
Setting the heat setting
The hob must be switched on with the main switch.
Each cooking zone has 9 heat settings with
intermediate settings in between. A dot appears next
to the heat setting display to indicate an intermediate
setting.
Heat setting 1 = lowest output
Heat setting 9 = highest output
1
Select the cooking zone. Do this by pushing the
magnetic knob towards the required cooking zone
symbol.
2
Centre the magnetic knob on the twistpad again.
3
Within the next 5 seconds, turn the magnetic
knob until the desired heat setting appears in the
heat setting display.
A signal sounds to confirm the setting after a few
seconds.
Changing the heat setting
Select the cooking zone. Use the magnetic knob to set
the required heat setting.
Switching off the cooking zone
Select the cooking zone. Use the magnetic knob to set
it to 0. The cooking zone switches off. After approx. 5
seconds, the residual heat indicator appears.
¯
¯
¯
¯
¯
