Gaggenau AW 540, Operating And Assembly Instruction Manual

Page: 19 / 24

– Secure the hood on the wall with the four screws
b (Fig. 21).
For exhaust air mode proceed as follows:
– Establish the pipe connection.
– Establish the electrical connection.
– Stainless steel chimney only (AD 010-012/022):
pull the protective film off the chimney’s trims.
Note: avoid damaging the sensitive metal surfaces.
– Fit the top chimney duct unit into the base. Make
sure that the fastening holes on the side are at the
top.
– Put both chimney duct units onto the hood.
– Pull the top chimney duct unit up into its final
position and secure it with 2 screws on the ceiling
holder (Fig. 22).
Note: avoid scratches when pulling the elements
apart by placing the assembly template, for
example, over the edge of the bottom chimney
paneling to protect it.
– Reinsert the grease filters.
– Place the glass plates on the appliance with the
printed side facing down.
Note: when putting the glass trays in place, make
sure that you do not scratch the chimney.
17
Fig. 21
Fig. 22