Gaggenau AW 540, Operating And Assembly Instruction Manual

Page: 18 / 24

16
Proceed as follows:
– From the bottom edge of the hood, mark a center
line on the wall.
– With the aid of the drilling template, mark the
positions of the screws on the wall (Fig. 19).
Note: this hood has been approved for installations
as low as 30 ´ ´ and as high as 36 ´ ´ above the cooktop.
– Using the drilling template, drill the 6 holes for
the hood (area I of the drilling template) and the
two holes for suspending the chimney (area II of
the drilling template). In the top two securing
holes for the hood, fix the two hooks
d with the
countersunk screws c . Make sure that the hooks
lie flatly on the wall. In certain circumstances you
may have to countersink the drill holes. Fit the
included dowels
a in the other drill holes.
Note: at least one screw must be installed
through a stud.
Note: pay attention to any special accessories that
you may have to fit.
– Screw on the retaining bracket for the chimney
paneling.
– Detach the grease filters.
– Hang the hood on the two hooks. Adjust the
suspended element with the recessed head
screw and align the hood using a spirit level
(Fig. 20).
396
62
270
300
(11
13
/
16
")
15 ( 19 /
32
")
310
230
76,5
1082
(12
3
/
16
")
(9 1 /
16
")
(10
5
/
8
")
(3")
(2
7
/
16
")
(15
9
/
16
")
(47
3
/
16
")
Fig. 19
Fig. 20
Important:
before marking the securing holes,
make sure that no electricity or water lines or
other lines are laid at the drilling points in the wall.
min. 30”