Gaggenau AL400721/01, Use And Care Manual

Page: 13 / 44

13
Installing metal grease filter
1 Insert metal mesh grease filter.
2 Fold metal mesh grease filter back in and snap the
lock in.
3 Reset the saturation display by pressing the
œ
button.
The saturation display
œ
goes out.
Close the filter cover
Grip filter cover in the middle and fold up.
The filter cover snaps in.
Clean the filter cover
For better cleaning, you can remove the filter cover.
1 Open the filter cover.
2 Grip the filter cover on the side with both hands.
3 Lift up the rear portion to the stop and pull the filter
cover forward.
The filter cover can be pulled using the bolts of the
holder.
4 Clean the filter cover
Hook in the filter cover
1 Grip the filter cover on the side with both hands.
2 Push the filter cover onto the bolts of the holder
and lift up in the front until it snaps in.
Faults – what to do?
You can often easily eliminate problems that may occur
on your own. Before calling customer service, take into
account the following information.
9
WARNING
Risk of electric shock
Improper repairs are dangerous. Only an
authorized servicer may perform repairs and may
replace damaged plug and connections. Remove
the power plug or turn off the circuit breaker or
fuse in the fuse box if the appliance is damaged
or not working. Call Customer Service.
LED lights
Defective LED lights may be replaced by the
manufacturer, his customer service or a qualified
technician (electrician) only.
9
WARNING
Risk of injury
The light emitted by LED lights is very dazzling,
and can damage the eyes (risk group 1). Do not
look directly into the switched on LED lights for
longer than 100
seconds.
Troubleshooting table
Disruption Possible cause Solution
Appliance is not
working Plug is not
plugged in Connect the appliance to
the mains
Power outage Check whether other
kitchen appliances are
working
Fuse defective Check in the fuse box
whether the fuse for the
appliance is in working
order
Appliance does
not retract. Filter cover not
closed. Close filter cover com-
pletely.
The button illu-
mination does
not work. The control unit
is faulty. Call customer service.
The lighting
does not work. The LED lights
are defective. Call Customer Support.
The
œ
button
flashes.
The filter is
soiled. Clean the filter, see the
chapter about
Cleaning
and maintenance
.