Gaggenau AA 490 711, Installation Instructions Manual, Page: 13 / 52

13
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Plug the control cable into the socket on the control
desk. The plug must snap into place.
2 Shorten the front clamp relative to the countertop
thickness
.
Break the metal sheets off at the
predetermined breaking points.
Note: Make sure that you do not shorten it too
much, the clamping effect to the countertop must
be guaranteed.
Insert and align the appliance in the cutout
horizontally. Tighten the rear clamp using the screw
inside the appliance. Tighten the front clamp from
below
.
Notes
‒ Do not overtighten the clamps, ensure that there
is a uniform seal gap on all sides.
‒ The rear clamp pivots out on its own during
tightening.
‒ The appliance must not be bonded to the
countertop with silicone.
3 Use the installation aid . Horizontally insert the
downdraft ventilation unit in the recess and align it.
Remove the sealing element. Insert the installation
aid at an angle into the ventilation recess and align
it vertically to the appliance. Position the appliance
at an angle in front of the downdraft ventilation unit
and press it into the recess via the installation aid.
Remove the installation aid. Fasten the downdraft
ventilation unit as described above.
0