en-us
Troubleshooting
44
Issue
Cause and troubleshooting
Excessive formation of foam
occurs.
Hand soap got in the rinse aid dispenser.
▶
Immediately add rinse aid to the dispenser.
Rinse aid has been spilled.
▶
Remove the rinse aid with a cloth.
Detergent or machine care product used causes excessive foaming.
▶
Change the brand of detergent.
Connection to home network is not
established.
WLAN on router is not active.
▶
Check the wireless network connection of your router.
WLAN display is flashing.
Connection to home network is not available.
▶
Activate the wireless network connection on your router.
Home Connect cannot be
implemented correctly.
Home Connect set incorrectly.
▶
Please consult the documents supplied for Home Connect®.
There is a technical error.
▶
Please consult the information on support in the documents supplied for
Home Connect®.
Special salt refill indicator lights up. Insufficient special salt.
▶
Add Special salt.
Sensor does not detect special salt tablets.
▶
Do not use special salt tablets.
Refill indicator for special salt does
not light up.
Water softening system is switched off.
▶
Set the water softening system.
"Setting the water softening system", Page 23
Refill indicator for rinse aid lights
up.
No rinse aid.
1.
Add Rinse aid
2.
Set the amount of rinse aid to be dispensed.
"Setting the amount of rinse aid", Page 25
Refill indicator for rinse aid does
not light up.
Rinse aid system is switched off.
▶
Set the amount of rinse aid.
"Setting the amount of rinse aid", Page 25
All LEDs light up or flash.
Electronics have detected a fault.
1.
Press the main switch button for approx. 4 seconds.
The appliance is reset and restarted.
2.
If the problem occurs again:
‒
Switch off the appliance.
‒
Unplug the power plug or switch off the circuit breaker in the fuse box.
‒
Wait at least 2 minutes.
‒
Switch on the circuit breaker in the fuse box or plug in the power plug.
‒
Switch on the appliance.
3.
If the problem occurs again:
‒
Contact customer service.
Water is left in the appliance at the
end of the program.
Filter system or area under the filters is blocked.
1.
Clean the Filters
2.
Clean the Drain pump
Program has not yet ended.
▶
Wait until the program ends or terminate the program with
Reset
.
▶
Summary of Contents for 400 Series
Page 1: ...en us Use and Care Manual DF480700F Dishwasher Gaggenau...
Page 51: ......
