Gage CompuScope 14100C, Hardware Manual And Driver Installation Manual

Page: 58 / 174

52 Driver installation guide
Section 2 – Verifying the operation of your hardware
Verifying installation and configuration of CompuScope hardware under
Windows 2000/XP with CompuScope Manager
If you wish to verify installation and configuration of your CompuScope cards under Windows 98/ME/NT,
please refer to the next section: Verifying installation and configuration of CompuScope hardware under
Windows 98/ME/NT with GageConfig.
The CompuScope Manager utility is used to verify the configuration your CompuScope cards under
Windows 2000/XP.
The CompuScope Manager utility is installed at the same time as the CompuScope 3.82 drivers. You can access
the CompuScope Manager from the Gage folder in the Programs category of the Start Menu of Windows.
The main screen of the CompuScope Manager is the Resource Manager tab (see Figure 50 below):
Figure 50: Card information from the Resource Manager tab of the CompuScope Manager
This screen provides you information about the Gage card or cards installed in your system. You can see the
type of card, the number of cards in the system, the number of channels on the card, the nominal resolution of the
card, the on-board memory, whether the card is active or inactive, and even the handle that the system has to
control the card from software (through the driver).