GADLEE GT 25 Series, Operator'S Manual, Page: 26 / 56

ENGLISH
14
i INFORMATION
If you use the machine for the first time, it is advisable that you train with it for a
short time on a wide surface without any obstacles, to acquire the necessary
familiarity.
Always empty the recovery tank before refilling the solution tank.
For an effective cleaning and long life of the equipment, it is necessary to follow some
simple rules:
• Prepare the work area, keeping away the possible obstacles;
• Begin to work starting from the farthest spot, in order to avoid trampling on the area
just-cleaned;
• Choose paths that are as much straight as possible;
• On wide floors divide the paths into rectangular and parallel areas.
At the end quickly mop the area, if necessary, to clean spots that are inaccessible to the
scrubber.
6.7 Work
After setting up the machine, proceed as follows:
• Connect the machine as follows:
- Cable model: plug the machine into the mains power socket;
• Lower the squeegee by means of the squeegee lever (fig. D, ref. 2);
• Press the main switch (fig. C, ref. 3) (led on); the suction motor and detergent flow
are also activated automatically;
• Press the brush button (fig. D, ref. 1);
• Check regularly that detergent is reaching the brushes and top up if necessary;
• While working, check the quality of washing and adjust the flow of detergent to the
brushes using the detergent tap (fig. G, ref. 2)

IMPORTANT
Empty the dirty water tank each time you fill the detergent tank.
• The float switch in the dirty water tank turns suction off when the tank is full. If the
switch trips, stop work and empty the tank;
• Battery models: if the red LED (fig. C, ref. 2) starts flashing, the batteries are nearly flat.
After a few seconds, the brush and suction motor shut down to prevent draining the
batteries excessively. Charge the batteries.
At the end of work:
• Release the brush button (fig. D, ref. 1);
• Press the detergent button (fig. C, ref. 6) (led off);
• Lift the squeegee lever (fig. D, ref. 2) to raise the squeegee from the floor to prevent
the continuous pressure from warping the blades;
• Press the suction button (fig. C, ref. 5) (led on) to start suction. Allow the suction to run
for 2 minutes, then press the suction button (fig. C, ref. 5) (led off) to turn the motor off.
• Turn the machine off by pressing the button (fig. C, ref. 3) (led off).
• Remove the brush (or drive disk) to prevent it from warping permanently;
• Depending on the model, unplug from the mains socket or disconnect the batteries,
• Empty and clean the dirty water tank.