TM-SS / TILTING
WALL MOUNT / SMALL
Wooden studs run vertically inside the wall, 16 inches apart, behind the drywall or plaster.
The wall bracket must be mounted to a wooden stud, or the bracket could fall out and
damage your display or cause personal harm. Four anchor screws (I) have been included
for use with the TM-SS, but you will need only two screws.
1.
Use a stud finder to locate the edges of the wooden studs, and mark the center of each stud.
2.
Place the wall bracket up to the marked locations, and use a pencil to mark drilling holes for the anchor screws. Use the
included bubble level to make sure the bracket is level before drilling.
3.
Use a 3/16-inch (4.5 mm) wood drill bit to predrill the marked spots 2.2 inches (55 mm) deep, and then clean out the
debris from the holes.
4.
Attach the bracket to the wall by inserting the two anchor screws through the washers and the wall brackets’ mounting
holes, and screw them into the predrilled support holes until secure. Use the wrench to further tighten the anchor
screws, but do not overtighten. Use the included bubble level to make sure the bracket is level.
Wooden Studs
wall bracket mounted to wooden stud, with correct screw placement.
10
Concrete
wall bracket mounted to concrete, with correct screw placement.
Attaching the Wall Bracket (cont.)
TM-SS / TILTING
WALL MOUNT / SMALL
