9
3 – EMITTER MODE:
This operation mode is used when it is necessary to heat the room temporarily and there is no need for storage heating.
Press the
key several times until the message
is displayed.
“Е”
stands for EMITTER.
“21.5” stands for the set up temperature in ºC.
Emitter will operate until the temperature in the room reach 21,5ºC, then, it will maintain the temperature.
If needed, it is possible to change the set up temperature by using the keys
and
. Temperature value will be
changing in steps of 0,5ºC.
Small red dot at the very right part of the display will show that the convector heating element is working at that moment.
Pressing simultaneously keys
and
will display room temperature taken from the sensor at the bottom of the
device.
It can be the case of a temperature difference between this sensor and a normal thermometer set up in a wall room. This is
because temperature is different at different heights in the room. The one at the floor is normally lower. User can adjust the
sensor so that different thermometers show same temperature. For this you can go to General Settings part and modify the
sensor reading according to P5 setting.
4 – ECOMBI MANUAL MODE:
This mode will allow ECOMBI to operate the Storage Heater and the Convector together in a combined way. The Storage
Heater will charge based on the settings of “AUTOMATIC STORAGE HEATER MODE” and if there is any kind of heat loss in
the room and a decrease in the temperature, ECOMBI may operate the “EMITTER MODE” to compensate and balance again the
room temperature.
To select this mode press the key
several times until in the display only appears the set up temperature. This is without
any preceding letter “A” or “E” displayed. I.e.
. This means that 21,5ºC is the system set up temperature (default).
It is possible to adjust the set up temperature by using the keys
and
. Temperature value will be changing in
steps of 0,5ºC.
When the convector heating element is working a small red dot will appear at the very right part of the display.
In this mode, the set up temperature is independent from the set up charging %. Default setting for charging % is 4 (80%). Please
read under “STORAGE HEATER mode” if you want to modify it.
While ECOMBI is charging (electric consumption) a small red dot will appear on the left side of the display
.
Storage Heater and Convector never work at the same time. This is, both powers never are added. Emitter may operate at any
time of the day or the night, including off-peak periods, but only if Storage Heater is not charging.
5 -ECOMBI AUTOMATIC MODE, with charge correction.
In this mode ECOMBI operates in a combined way. Storage heater operates during off peak rate, and when it is not being
charged, ECOMBI may operate as Emitter providing additional heating to the room if necessary.
BESIDES THIS THERE WILL BE AN AUTOMATIC CHARGE CORRECTION OF THE STORAGE HEATER FOR THE
FOLLOWING DAYS.
To activate this mode press the
key for several times until the message
is displayed.
А
stands for AUTOMATIC mode.
21,5 is the set up temperature in ºC.
When the Emitter is on, a small red dot at the very right of the screen will be displayed.
