Troubleshooting
Fault
Possible cause
Suggested remed
y
Device does not function, LED
does not glow.
There is no voltage present in
the 12/24 V socket (cigarette
lighter) in your vehicle.
The ignition must be switched
on in most vehicles to apply
current to the cigarette lighter.
No voltage present in the AC
voltage socket.
Try using another plug socket.
The device fuse is defective.
Replace the device fuse, see
“Replacing the device fuse”.
The integrated mains adapter
is defective.
This can only be repaired by
an authorized repair centre.
The device does not cool (plug
is inserted “POWER” LED is lit).
Defective compressor.
This can only be repaired by
an authorized customer servi-
ces unit.
The device does not cool (plug
is inserted, “POWER” LED
flashed orange, display is swit-
ched off).
Battery voltage is too low.
Test the battery and charge it
as needed.
When operating from the
12/24-V socket (cigarette ligh-
ter): The ignition is on and the
device is not working and the
LED is not lit. Pull the plug out
of the socket and make the fo-
llowing checks.
The cigarette lighter socket
is dirty. This results in a poor
electrical contact.
If the plug of your cooler be-
comes very warm in the ciga-
rette lighter socket, either the
lighter socket must be clea-
ned or the plug has not been
assembled correctly.
The fuse of the 12/24 V plug
has blown.
Replace the fuse(10A) in the
12/24 V plug, see “ Replacing
the plug fuse(12/24 V)”.
The Vehicle fuse has blown.
Replace the vehicle’s 12/24 V
socket fuse(usually 15 A).
Please refer your vehicle’s
operating manual.
The display shows an error
message(e.g. “Err1”) and the
appliance does not cool.
The appliance has switched
off due to an internal fault.
This can only be repaired by an
authorized repair centre.
Summary of Contents for C&F 50 l
Page 1: ...HU PL SK DE EN CZ COOL BOX C F 50 l C F 60 l ...
Page 2: ......
Page 67: ......
Page 68: ......
