Opening the safe using the emergency key
In the case of forgotten code or when there is a technical problem of electronic lock it is possible
to open the safe with using emergency key.
Remove the cover next to the keyboard.
Insert the key into the lock for emergency opening and turn counterclockwise. Then turn the han-
dle clockwise.
Mounting process
Put the safe to the place that can not be easily manipulated.
Drill the holes for the dowels.
Turn expansion screws counterclockwise.
Fix the safe on the wall with using expansion screws (or clamping screws).
Make sure the safe is correctly attached to the dowels and tighten.
Warning:
use expansion screws to the concrete wall. Clamping screws use on the wooden walls.
Wall
Wall
Wall
Opening the door
Enter your security number (3-8 numbers). Each press will be signalized by a beep and by flashing
yellow light.
Pressing A (C / #) or B (E / *) will light up green light.
Turn the handle clockwise and pull out. Door will be opened.
Warning:
The preset code is 159. If you enter the wrong code, yellow LED flashes and the safe
beeps three times. Please enter the code again.
Closing the door
Turn the handle counterclockwise.
Automatic locking
If you enter the wrong code three times, safe will be locked and will run the warning beeps
for 20 seconds.
3 more bad entering will lock the safe and the safe will run the beeps for 5 minutes.
Warning: The keyboard is inactive during beeping. If you want to stop beeping, you have to open
the door using the emergency key and remove the batteries.
Entering the security code
Open the safe and press the RESET button on the inner side of the safe door. You will hear a beep
and on the keyboard will flash the yellow LED.
Enter the new code (3-8 numbers). By pressing A (C / #) or B (E / *) confirm the setting. The lock
signalizes by a short beep that the new code is setted. The yellow LED goes out.
If you enter the wrong code the yellow LED flashes and you will hear 3 beeps. It is necessary
to enter the code again.
Entering the main security code
Open the safe and press the key O two times, then press the RESET button on the inner side
of the door. The yellow LED lights up. Start to set up the code.
Enter the new code (3-8 numbers). By pressing A or B confirm the setting. Safe beeps two times
and also the yellow LED blinks two times. The code is setted successfully.
When the yellow LED blinks three times, it means invalid setting of the code and it is necessary
to repeat the process again.
The English version of the manual is an exact translation of the original manufacturer‘s instructions.
Images used in this manual are for illustrational purposes only and may differ from the actual product.
Summary of Contents for 639220
Page 1: ...DIGITAL SAFE HU PL SK DE EN CZ HR SLO ...
Page 15: ......
